New Page 1
The Heatmiser HC-N is our network-able heating and cooling thermostat offering
three modes of operation ideal for 2 and 4 pipe systems. It provides a three
speed fan output which can be set to manual or automatic mode.
Heating: In heating mode, you are able to set 4 switching times for
the weekday and 4 different switching times for the weekend. Two temperature
settings can be programmed (Day, Night)
During a switching time, the day temperature will be maintained, switching
the fan between low, medium and high depending on the actual temperature when
set in automatic mode. Outside the programmed times, the night temperature will
be maintained.
Cooling: In cooling mode, 4 switching times can be set along with a
cooling set point. The cooling output will be active when the actual temperature
rises above the set point. With the fan in automatic mode, the HC will switch
between low, medium and High 1ºC ,2ºC
or 3ºC above the set point.
Automatic: In automatic mode, 4 switching times per day can be set
along with a Day and Night heating and a single cooling set point. In addition,
a dead band setting is programmed ensuring there is no conflict between the
heating and cooling. During the switching time, the heating set temperature will
be maintained switching the fan between low, medium and high. Should the room
temperature rise above the cooling set point, the cooling output will be active
along with the fan.
The following features are available;
Large display
Automatic blue back-light (Turns off after 30 seconds)
Flush mounting
°C / °F Selectable
Self Learning Optimum Start
(Heating and Auto Mode only)
TouchPad Compatible
Heating, Cooling and Automatic modes available
Heating Output
Cooling Output
3 Speed Fan Output
30 minute timing increments
5 day/2 day Program
(Weekday/Weekend programming)
Up to 4 changes in room temperature
Fan speed: Auto, High, Medium, Low
Frost protection
Easily increase or decrease the required temperature
Temperature range 05°C - 35°C
Supply: 12v
Outputs: 12V
Manual
Download
