The Heatmiser PRT-EN is our low voltage under-floor heating thermostat. It provides two modes of operation which can be selected in software by the installer. Mode 0 is designed to work with a remote floor sensor and controls only floor temperature. In mode 1, the thermostat will maintain the desired air temperature and will use the floor sensor to prevent the floor from overheating.

The following features are available;
 

• Large display
• Self Learning Optimum Start
• Automatic blue back-light (Turns off after 30 seconds)
• Flush mounting
• °C / °F Selectable
• Heatmiser TouchPad, PCLink, Netmonitor Compatible
• Time Sync (When used with TouchPad / PCLink)
• 30 minute timing increments
• 5 day/2 day Program
  (Weekday/Weekend programming)
• Up to 4 changes in room temperature
• Key Locking Facility
• Frost protection with adjustable temperature setting.
• Easily increase or decrease the required temperature
• Temperature range 05°C - 70°C Mode 0
• Temperature range 05°C - 35°C Mode 1
• Remote control optional
• Supply: 12v
• Outputs: Volt free 3A Max
• Dimensions:  98mm x  85mm x 13mm (Height, Width, Depth)

  (Please note 13mm depth is after installation)

   

Manual Download

Mounting: This thermostat is flush mounting, and therefore requires a back box sunk in the wall to accommodate the terminal box for the thermostat. We suggest a back box of 35mm which you can buy here.